Asus AP1600R-E2 User Manual download pdf (Page 50)

Chapter 4: Motherboard informationChapter 4: Motherboard information

Chapter 4: Motherboard information

4-84-8

4-8

2.2.

IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

These connectors are for Ultra DMA 100/66 signal cables. The Ultra

DMA 100/66 signal cable has two connectors: a blue connector for the

primary IDE connector on the motherboard and a black connector for an

Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive). If

you install two hard disk drives, you must configure the second drive as

a slave device by setting its jumper accordingly. Refer to the hard disk

documentation for the jumper settings.

4.3 Connectors

1.1.

Floppy disk drive connector (34-1 pin FLOPPY)Floppy disk drive connector (34-1 pin FLOPPY)

Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other

end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection

when using a FDD cable with a covered Pin 5.

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

NCLV-D

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

NCLV-D Floppy disk drive connector

PIN 1

FLOPPY

NCLV-D

NCLV-D IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

SEC_IDE1

PRI_IDE1

PIN 1

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 95 96

No comments

Asus AP1600R-E2 User Manual Page 50