Asus Dual Pentium II Department Server AP2500 User Manual download pdf (Page 23)

AP2500 Hardware Reference Guide 23

II. Components

II. System Components

Hot-Swap Bay

There are two levers on the front

of the hot swap tray to help re-

lease or lock the tray. To remove

the tray, extend both levers and

pull on both levers. To install

the tray, push the tray firmly into

the bay with the levers extended,

then close the levers. Three hard

disk drive LEDs are located in-

side the system fan module for

each hard disk drive tray. LEDs

provide information on the power and activity status of the hard disk drive.

When power is received by the hot-swap tray’s connector board, the power

LED will light. When data is written or read to or from the contained hard

disk drive, the activity LED will flash proportional to the amount of data

transferred.

Hot-Swap Tray

Each hot-swap tray provides an alumi-

num carrier for a single SCSI hard disk

drive with a maximum height of 1 inch

or 1.6 inch (depending on model), a

width of 4 inches, and a length of 6

inches. The aluminum tray provides pro-

tection and maximum heat dissipation

for almost all types of high speed SCSI

disk drives. The provided screws are

needed to secure the hard disk drive into

the tray.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Asus Dual Pentium II Department Server AP2500 User Manual Page 23