Asus Motherboard P5VDC-MX User Manual download pdf (Page 39)

ASUS P5VDC-MXASUS P5VDC-MX

ASUS P5VDC-MX

1-271-27

1-27

2.2.

Primary/Secondary IDE connector (40-1 pin PRI_IDE,Primary/Secondary IDE connector (40-1 pin PRI_IDE,

Primary/Secondary IDE connector (40-1 pin PRI_IDE,

SEC_IDE)SEC_IDE)

SEC_IDE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal

cables. There are three connectors on each Ultra DMA 133/100/66

signal cable: blue, black, and gray. Connect the blue connector to the

motherboard’s IDE connector, and then select one of the following

modes to configure your device.

P5VDC-MX

P5VDC-MX IDE connectors

NOTE: Orient the red marking

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PIN 1

PRI_IDE

SEC_IDE

PIN 1

1. Follow the hard disk drive documentation when setting the device in

master or slave mode.

2. Pin 20 on each IDE connector is removed to match the covered hole

on the UltraATA cable connector. This prevents incorrect orientation

when you connect the cables.

3. The hole near the blue connector on the UltraATA cable is

intentional.

If any device jumper is set as “Cable-Select, ” make sure all other device

jumpers have the same settng.

Drive jumper setting Mode of derve(s) Cable connector

Single device Cable-Select or Master - black

Cable-Select Master black

Slave gray

Two devices Master Master black or gray

Slave Slave

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 93 94

No comments

Asus Motherboard P5VDC-MX User Manual Page 39