Asus P4SP-MX User Manual download pdf (Page 50)

2-18

Chapter 2: BIOS information

2.4.1 Chip Configuration

SDRAM Configuration [By SPD]

This parameter allows you to set the optimal timings for items 2–5, depending on

the memory modules you are using. The default setting is [By SPD], which

configures items 2 ~ 5 by reading the contents in the SPD (Serial Presence Detect)

device. The EEPROM on the memory module stores critical information about the

module, such as memory type, size, speed, voltage interface, and module banks.

Configuration options: [User Defined] [By SPD]

SDRAM CAS Latency (XT)

This item controls the latency between the SDRAM read command and the actual

time the data becomes available. Configuration options: [2.5T] [2T] [1.5T] [3T]

SDRAM RAS to CAS Delay (XT)

This item controls the latency between the DDR SDRAM active command and the

read/write command. Configuration options: [3T] [2T] [4T]

SDRAM RAS Precharge Time (XT)

This item controls the idle clocks after issuing a precharge command to the DDR

SDRAM. Configuration options: [3T] [2T] [4T]

SDRAM Active Time (XT)

This item controls the number of DDR SDRAM clocks used for DDR SDRAM

parameters. Configuration options: [6T] [7T] [5T] [4T]

SDRAM Command Lead-off Time [Auto]

Configuration options: [Auto] [2T] [1T]

The SDRAM parameters (items 2 ~ 5) are user-configurable only when you set

the SDRAM Configuration to [User Defined].

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 63 64

No comments

Asus P4SP-MX User Manual Page 50