Asus E2KM1I-DELUXE User Manual download pdf (Page 29)

1.8.2 Internal connectors

1. CPU and chassis fan connectors (4-pin CPU_FAN, and 4-pin CHA_FAN)

Connect the fan cables to the fan connectors on the motherboard, ensuring that the

black wire of each cable matches the ground pin of the connector.

• The CPU_FAN connector supports a CPU fan of maximum 2A (24 W) fan power.

• Only the 4-pin CPU fan and 4-pin chassis fan support the ASUS Fan Xpert feature.

DO NOT forget to connect the fan cables to the fan connectors. Insufcient air ow inside

the system may damage the motherboard components. These are not jumpers! DO NOT

place jumper caps on the fan connectors.

E2KM1I-DELUXE

E2KM1I-DELUXE Fan connectors

CHA_FAN

PWM Mode

CPU FAN IN

CHA FAN PWR

GND

CPU_FAN

CPU FAN PWM

CPU FAN IN

CPU FAN PWR

GND

2. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect

one end of the chassis intrusion sensor or switch cable to this connector. The chassis

intrusion sensor or switch sends a high-level signal to this connector when a chassis

component is removed or replaced. The signal is then generated as a chassis intrusion

event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper

cap. Remove the jumper caps only when you intend to use the chassis intrusion

detection feature.

E2KM1I-DELUXE

E2KM1I-DELUXE Chassis intrusion connector

GND

Chassis Signal

+5VSB_MB

CHASSIS

ASUS E2KM1I-DELUXE

1-17

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 69 70

No comments

Asus E2KM1I-DELUXE User Manual Page 29