Asus CUV4X-DLS User Manual download pdf (Page 39)

ASUS CUV4X-DLS User’s Manual 39

3. HARDWARE SETUP

Connectors

3. H/W SETUP

9) Standard Infrared Module Connector (5-pin IR)

This connector supports an optional wireless transmitting and receiving infrared

module. This module mounts to a small opening on system cases that support

this feature. You must also configure the setting through UART2 Use Infrared

(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for

use with COM2 or IrDA. Use the five pins as shown in Back View and connect

a ribbon cable from the module to the motherboard SIR connector according to

the pin definitions.

10) Chassis Intrusion Lead (4-1 pin CHASSIS)

This lead is for a chassis designed for chassis intrusion detection. This requires

an external detection mechanism such as a chassis intrusion monitor/sensor or

microswitch. When any chassis component is removed, the sensor is triggered

and a high-level signal is sent to this lead to record a chassis intrusion event.The

event is then be processed by software such as LDCM. When not using the

chassis intrusion lead, place a jumper cap over the pins to close the circuit.

CUV4X-DLS

CUV4X-DLS Infrared Module Connector

Front View Back View

+5V

IRTX

IRRX

(NC)

GND

+5V

IRRX

IRTX

(NC)

GND

CUV4X-DLS

CUV4X-DLS Chassis Open Alarm Lead

CHASSIS

+5Volt

(Power Supply Stand By)

Ground

Chassis Signal

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 99 100

No comments

Asus CUV4X-DLS User Manual Page 39