Asus K7V User Manual download pdf (Page 40)

40 ASUS K7V User’s Manual

3. HARDWARE SETUP

Connectors

3. H/W SETUP

12) IDE Activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read and

write activity by devices connected to the Primary or Secondary IDE connectors

will cause the LED to light up.

K7V IDE Activity LED

TIP: If the case-mounted LED does not

light, try reversing the 2-pin plug.

IDELED

0 1

K7V

13) Power Supply (PWR_FAN), CPU (CPU_FAN), Chassis (CHA_FAN /

F_FAN) Fan Connectors (3 pins)

These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan’s plug to the board taking into consid-

eration the polarity of the connector.

NOTE: The “Rotation” signal is to be used only by a specially designed fan with

rotation signal. The Rotations per Minute (RPM) can be monitored using ASUS PC

Probe or Intel LDCM Utility. The Rotation signal is not supported by F_FAN.

WARNING! The CPU and/or motherboard will overheat if there is no airflow

across the CPU and onboard heatsinks. Damage may occur to the motherboard

and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

0 1

K7V

K7V 12-Volt Cooling Fan Power

CHA_FAN

PWR_FAN

GND

Rotation

+12V

GND

Rotation

+12V

F_FAN

CPU_FAN

GND

+12V

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 109 110

Comments to this Manuals

No comments

Asus K7V User Manual Page 40

Comments to this Manuals

Related products and manuals for Motherboards Asus K7V