Asus K8N4-E Specifications download pdf (Page 39)

ASUS K8N4-EASUS K8N4-E

ASUS K8N4-E

1-271-27

1-27

2.2.

IDE connectors (40-1 pin PRI_IDE, SEC_IDE)IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

These connectors are for Ultra DMA 133/100/66 signal cables. The

Ultra DMA 133/100/66 signal cable has three connectors: a blue

connector for the primary IDE connector on the motherboard, a black

connector for an Ultra DMA 133/100/66 IDE slave device (optical

drive/hard disk drive), and a gray connector for an Ultra DMA 133/

100/66 IDE master device (hard disk drive). If you install two hard disk

drives, you must configure the second drive as a slave device by setting

its jumper accordingly. Refer to the hard disk documentation for the

jumper settings.

• The Pin 20 on the IDE connector is removed to match the covered

hole on the Ultra DMA cable connector. This prevents incorrect

insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for UltraDMA133/100/66 IDE

devices.

K8N4-E

K8N4-E IDE connectors

SEC_IDE

PRI_IDE

PIN 1PIN 1

NOTE: Orient the red marking

(usually zigzag) on the IDE

ribbon cable to PIN 1.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 91 92

No comments

Asus K8N4-E Specifications Page 39