Asus P5QL-VM EPU Specifications download pdf (Page 23)

ASUS P5QL-VM EPU 1-13

1.7.2 Memory congurations

You may install 512MB, 1GB, 2GB, and 4GB unbuffered non-ECC DDR2 DIMMs into the

DIMM sockets.

• When using only one DDR2 DIMM, start installing it from DIMM_A1 or DIMM_B1 for

better overclocking capability.

• For dual-channel conguration (1), install two identical DIMMs in DIMM_A1 and

DIMM_B1.

• For dual-channel conguration (2), you can:

- install four identical DIMMs in all four slots; or

- install one identical DIMM pair in DIMM_A1 and DIMM_B1 (yellow slots) and

another identical DIMM pair in DIMM_A2 and DIMM_B2 (black slots).

• Always install DIMMs with the same CAS latency. For optimum compatibility, it is

recommended that you obtain memory modules from the same vendor.

• Due to the memory address limitation on 32-bit Windows

OS, when you install 4GB

or more memory on the motherboard, the actual usable memory for the OS can be

about 3GB or less. For effective use of memory, we recommend that you do any of the

following:

- Use a maximum of 3GB system memory if you are using a 32-bit WindowsUse a maximum of 3GB system memory if you are using a 32-bit Windows

OS.

- Install a 64-bit WindowsWindows

OS when you want to install 4GB or more memory on

the motherboard.

• This motherboard does not support DIMMs made up of 256 megabits (Mb) or less.

• This motherboard supports up to 16GB on Windowsindows

XP Professional x64 and

Windows

Vista x64 editions. You may install a maximum of 4GB DIMMs on each slot.. You may install a maximum of 4GB DIMMs on each slot.

• The default memory operation frequency is dependent on its Serial Presence Detect

(SPD), which is the standard way of accessing information from a memory module.

Under the default state, some memory modules for overclocking may operate at a lower

frequency than the vendor-marked value.

• For system stability, use a more efcient cooling system to support a full memory load (4

DIMMs) or overclocking conditions.

• Some old-version DDR2-800 DIMMs may not match Intel

’s On-Die-Termination (ODT)

requirement and will automatically downgrade to run at DDR2-667. If this happens,

contact your memory vendor to check the ODT value.

• Due to chipset limitation, DDR2-800 with CL=4 will be downgraded to run at DDR2-667

by default setting. If you want to operate with lower latency, adjust the memory timing

manually.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 63 64

No comments

Asus P5QL-VM EPU Specifications Page 23