Asus K8N-DRE User Manual download pdf (Page 43)

ASUS K8N-DREASUS K8N-DRE

ASUS K8N-DRE

2-232-23

2-23

2.2.

IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

These connectors are for Ultra DMA 133/100/66 signal cables. The

Ultra DMA 133/100/66 signal cable has three connectors: a blue

connector for the primary IDE connector on the motherboard, a black

connector for an Ultra DMA 133/100/66 IDE slave device (optical

drive/hard disk drive), and a gray connector for an Ultra DMA 133/

100/66 IDE master device (hard disk drive). If you install two hard disk

drives to the same cable, you must configure the second drive as a

slave device by setting its jumper accordingly. Refer to the hard disk

documentation for the jumper settings.

2.7.22.7.2

2.7.2

Internal connectorsInternal connectors

Internal connectors

1.1.

Floppy disk drive connector (34-1 pin FLOPPY1)Floppy disk drive connector (34-1 pin FLOPPY1)

Floppy disk drive connector (34-1 pin FLOPPY1)

This connector is for the provided floppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other

end to the signal connector at the back of the floppy disk drive.

• The Pin 20 on the IDE connector is removed to match the covered

hole on the Ultra DMA cable connector. This prevents incorrect

insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA133/100/66 IDE

devices.

K8N-DRE

NOTE: Orient the red markings o

the floppy ribbon cable to PIN 1.

FLOPPY1

K8N-DRE Floppy disk drive connector

K8N-DRE

K8N-DRE IDE connectors

PRI_IDE1

SEC_IDE1

NOTE: Orient the red marking

(usually zigzag) on the IDE

ribbon cable to PIN 1.

1 ... 42 43 44 ... 142

Comments to this Manuals

No comments

Asus K8N-DRE User Manual Page 43

Comments to this Manuals

Related products and manuals for Computer hardware Asus K8N-DRE