Asus P9D-MV User Manual download pdf (Page 114)

5-10

Chapter 5: RAID conguration

Select a destination disk with the same size as the original hard disk.

5.2.5 Rebuilding the RAID

This option is only for the RAID 1 set.

Rebuilding the RAID with another non-RAID disk

If any of the SATA hard disk drives included in the RAID 1 array failed, the system displays

the status of the RAID volume as “

Degraded

” during POST. You can rebuild the RAID array

with other installed non-RAID disks.

To rebuild the RAID with another non-RAID disk:

1. During POST, press <Ctrl>+<I> at the prompt to enter the Intel

Rapid Storage

Technology option ROM utility.

2. If there is a non-RAID SATA Hard Disk available, the utility will prompt you to rebuild the

RAID. Press the up/down arrow keys to select the destination disk then Press <Enter>

to start the rebuilding process or press <ESC> to exit.

5.2.4 Exiting the Intel

Rapid Storage Technology enterprise

SATA Option ROM utility

To exit the utility:

1. From the utility main menu, select

4. Exit

then press <Enter>.

2. From the following warning message, press <Y> to exit or press <N> to return to the

utility main menu.

Select the port of destination disk for rebuilding (ESC to exit):

Port Drive Model Serial # Size

X XXXXXXXXXXX XXXXXXXX XXX.GB

“Degraded” volume and disk available for rebuilding detected. Selectign

a disk initiates a rebuild. Rebuild completes in the operating system.

[ ]-Previous/Next [ENTER]-Select [ESC]-Exit

[ DEGRADED VOLUME DETECTED ]

Are you sure you want to exit? (Y/N):

[ CONFIRM EXIT ]

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 155 156

No comments

Asus P9D-MV User Manual Page 114