Chapter 2: Hardware setup2-8
2.3 Hard disk drives
The system supports four hot-swap SATAII/SAS hard disk drives. The hard disk
drive installed on the drive tray connects to the motherboard SATAII/SAS ports via
the SATAII/SAS backplane. Follow the illustration below for HDD installation.
5. Push the tray lever until it clicks, and secures the drive tray in place. The
drive tray is correctly placed when its front edge aligns with the bay edge.
6. Repeat steps 1 to 5 if you wish to install a second SATAII/SAS drive.
To install a hot-swap SATAII/SAS HDD
1. Release a drive tray by pushing the
spring lock to the right, and then
pulling the tray lever outward. The
drive tray ejects slightly after you
pull out the lever.
2. Firmly hold the tray lever and pull
the drive tray out of the bay.
3. Place a SATAII/SAS hard disk drive
on the tray, and then secure it with
four screws.
4. Carefully insert the drive tray and
push it all the way to the depth of
the bay until just a small fraction of
the tray edge protrudes.
When installed, the SATAII/SAS
connector on the drive connects
to the SATAII/SAS interface on
the backplane.
Comments to this Manuals