Asus Motherboard A8V-XE User Manual Page 64

  • Download
  • Add to my manuals
  • Print
  • Page
    / 86
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 63
2-22 Chapter 2: BIOS setup
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select Sub-menu F10: Save and Exit
Select Menu
Item Specific Help
<Enter> to select DARM
configuration by
[Auto] is recommended.
[Manual] allows you to
set each
configuration on your
own.
DRAM Configuration
Current DRAM Frequency 166 MHz
Timing Mode [Auto]
x Memclock index value (Mhz) 200Mhz
x CAS# latency (Tcl) 3
x Min RAS# active time(Tras) 8T
x RAS# to CAS# delay (Trcd) 4T
x Row precharge Time (Trp) 4T
x 1T/2T Memory Timing 2T
S/W DRAM Over 4G Remapping [Enabled]
H/W DRAM Over 4G Remapping [Enabled]
MTRR mapping mode [Continous]
Phoenix-Award BIOS CMOS Setup Utility
Advanced
Current DRAM Frequency
Shows the Transfer mode. This item is not configurable.
Timing Mode [Auto]
Sets the timing mode. Configuration options: [Auto] [Manual]
Memclock index value (Mhz)
Shows the memory clock index value. This item is not configurable.
CAS# latency (Tcl)
Shows the latency between the SDRAM read command and the time
the data actually becomes available.This item is not configurable.
Min RAS# active time (Tras)
Shows the minimum RAS# active time. This item is not configurable.
RAS# to CAS# delay (Trcd)
Shows the latency between the DDR SDRAM active command and the
read/write command. This item is not configurable.
Row precharge Time (Trp)
Shows the Row precharge time.This item is not configurable.
1T/2T Memory Timing
Shows the memory timing. This item is not configurable.
S/W DRAM Over 4G Remapping [Enabled]
Enables or disables the S/W DRAM over 4G remapping mode
Configuration options: [Disabled] [Enabled]
H/W DRAM Over 4G Remapping [Enabled]
Enables or disables the H/W DRAM over 4G remapping mode
Configuration options: [Disabled] [Enabled]
Page view 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 85 86

Comments to this Manuals

No comments