Asus Pundit P2-PE2 User Manual download pdf (Page 40)

4-44-4

4-4

Chapter 4: Motherboard infoChapter 4: Motherboard info

Chapter 4: Motherboard info

4.3 Connectors

4.3.14.3.1

4.3.1

Rear panel connectorsRear panel connectors

Rear panel connectors

Refer to section “1.3 Rear panel” for a description of the rear panel I/O ports.

4.3.24.3.2

4.3.2

Internal connectorsInternal connectors

Internal connectors

1.1.

Primary IDE connector (40-1 pin PRI_IDE)Primary IDE connector (40-1 pin PRI_IDE)

Primary IDE connector (40-1 pin PRI_IDE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra

DMA 100/66 signal cable has three connectors: a blue connector for

the primary IDE connector on the motherboard, a black connector for

an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),

and a gray connector for an Ultra DMA 100/66 IDE master device (hard

disk drive). If you install two hard disk drives, you must configure the

second drive as a slave device by setting its jumper accordingly. Refer

to the hard disk documentation for the jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

IDE connector

PIN 1

PRI_IDE

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 71 72

No comments

Asus Pundit P2-PE2 User Manual Page 40