Asus P/E-P55T2P4D User Manual download pdf (Page 29)

P/E-P55T2P4D User’s Manual 23

III. INSTALLATION

(Connectors)

III. INSTALLATION

5. Floppy drive connector (34-pin block )

This connector supports the provided floppy drive ribbon cable.

After connecting the single end to the board, connect the two plugs

on the other end to the floppy drives.

Floppy Drive Connector

Pin 1

6. Primary / Secondary IDE connectors (Two 40-pin Block)

This connector supports the provided IDE hard disk ribbon cable. After con-

necting the single end to the board, connect the two plugs at the other end to

your hard disk(s). If you install two hard disks, you must configure the second

drive to Slave mode by setting its jumpers accordingly. Please refer to the

documentation of your hard disk for the jumper settings. You may also config-

ure two hard disks to be both Masters using one ribbon cable on the primary

IDE connector and another ribbon cable on the secondary IDE connector.

Primary IDE Connector

Secondary IDE Connector

Pin 1

1 ... 28 29 30 ... 63

No comments

Asus P/E-P55T2P4D User Manual Page 29