2-24 Chapter 2: BIOS setup
DRAM Frequency [Auto]
Allows you to set the DDR operating frequency.
Conguration options: [Auto] [533 MHz] [667 MHz] [800 MHz] [1067 MHz]
Congure DRAM Timing by SPD [Enabled]
When this item is enabled, the DRAM timing parameters are set according to the
DRAM SPD (Serial Presence Detect). When disabled, you can manually set the
DRAM timing parameters through the DRAM sub-items.
Conguration options: [Enabled] [Disabled]
Memory Hole [Disabled]
Allows you to enable or disable the memory hole. Conguration options: [Disabled]
[15MB-16MB]
DRAM 1N Mode Select [Disabled]
Allows you to select the DRAM 1N mode. When selecting [Auto], the chipset enters
1N mode for DDR2-533 or DDR2-667. When disabled, the chipset utilizes 2N
mode for all memory congurations. Conguration options: [Auto] [Disabled]
Initiate Graphic Adapter [PEG/PCI]
Allows you to select the graphics controller as the primary boot device.
Conguration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
Internal Graphics Mode Select [Enabled, 8MB]
Allows you to select the amount of system memory used by the Internal graphics
device. Conguration options: [Disabled] [Enabled,1MB] [Enabled, 8MB]
PEG Port Conguration
PEG Port [Auto]
Conguration options: [Auto] [Disabled]
PEG Force x1 [Disabled]
Conguration options: [Enabled] [Disabled]
Available DRAM frequency options in various FSB settings
* Provided for overclocking purpose only.
Selecting a very high DRAM frequency may cause the system to become
unstable! If this happens, revert to the default setting.
FSBCongurationoptions
Auto DDR2- DDR2- DDR2- DDR2-
533 667 800 1067*
FSB 1066 • • • • •
FSB 800 • • • •
Comments to this Manuals