Asus P5P41C User Manual download pdf (Page 34)

1-24 Chapter 1: Product introduction

2. IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal cable. There are

three connectors on each Ultra DMA 133/100/66 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to congure your device.

Drive jumper setting Mode of device(s) Cable connector

Single device Cable-Select or Master - Black

Two devices

Cable-Select

Master Black

Slave Gray

Master Master

Black or gray

Slave Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

PRI_IDE

NOTE:Orient the red markings

on the IDE ribbon cable to PIN 1.

PIN1

P5P41C

P5P41C IDE connector

If any device jumper is set as “Cable-Select,” ensure that all other device jumpers have the

same setting.

1 ... 33 34 35 ... 62

No comments

Asus P5P41C User Manual Page 34