Asus P5VD2-VM SE User Manual Page 44

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 43
1-32 Chapter 1: Product introduction
7. ATX power connectors (24-pin EATXPWR,
4-pin ATX12V)
These connectors are for an ATX power supply. The plugs from the power
supply are designed to t these connectors in only one orientation. Find the
proper orientation and push down rmly until the connectors completely t.
Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the
system will not boot up.
Use a PSU with a minimum power rating of 300 W on this motherboard.
Use of a PSU with a higher power output is recommended when
conguring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
®
P5VD2-VM SE
P5VD2-VM SE ATX power connectors
EATXPWRATX12V
+12V DC
GND
+12V DC
GND
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground
8. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
®
P5VD2-VM SE
P5VD2-VM SE Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
Page view 43
1 ... 43 44 45 ... 100

Comments to this Manuals

No comments