Asus TUEP2-M User Manual download pdf (Page 35)

ASUS TUEP2-M User’s Manual 35

3. HARDWARE SETUP

Connectors

3. H/W SETUP

3) IDE Activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read and

write activity by devices connected to the Primary or Secondary IDE connectors

will cause the LED to light up.

TUEP2-M

TUEP2-M IDE Connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

Secondary IDE Connector

PIN 1

Primary IDE Connector

TUEP2-M

TUEP2-M IDE Activity LED

TIP: If the case-mounted LED does not

light, try reversing the 2-pin plug.

IDELED

4) Power Supply (PWR_FAN), CPU (CPU_FAN), Chassis (CHA_FAN) Fan

Connectors (3 pins)

These connectors support cooling fans of 350mA (4.2 Watts) or less. Orientate

the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan’s plug to the board taking into

consideration the polarity of the connector.

NOTE: The “Rotation” signal is to be used only by a specially designed fan with

rotation signal. The Rotations per Minute (RPM) can be read directly from the

ASUS iPanel or monitored using a utility such as ASUS PC Probe or Intel LDCM.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 103 104

No comments

Asus TUEP2-M User Manual Page 35