Asus A8AE-LE User's Guide Page 14

  • Download
  • Add to my manuals
  • Print
  • Page
    / 18
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 13
10
ASUS A8AE-LE (Amberine/AmberineM) Motherboard
4. IDE connectors (40-1 pin IDE1, IDE2)
This connector supports the provided UltraDMA100/66/33 IDE hard disk ribbon
cable. Connect the cable’s blue connector to the primary (recommended) or
secondary IDE connector, then connect the gray connector to the UltraDMA100/66/
33 slave device (hard disk drive) and the black connector to the UltraDMA100/66/
33 master device. It is recommended that you connect non-UltraDMA100/66/33
devices to the secondary IDE connector. If you install two hard disks, you must
configure the second drive as a slave device by setting its jumper accordingly.
Refer to the hard disk documentation for the jumper settings. BIOS supports specific
device bootup. If you have more than two UltraDMA100/66/33 devices, purchase
another UltraDMA100/66/33 cable. You may configure two hard disks to be both
master devices with two ribbon cables – one for the primary IDE connector and
another for the secondary IDE connector.
1. Pin 20 on each IDE connector is removed to match the covered hole on the
UltraDMA cable connector. This prevents incorrect orientation when you connect
the cables.
2. The hole near the blue connector on the UltraDMA100/66/33 cable is intentional.
A8AE-LE
A8AE-LE IDE connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
IDE1
PIN 1
IDE2
PIN 1
3. Serial ATA connectors (7-pin SATA1, SATA0)
These next generation connectors support the thin Serial ATA cables for
primary internal storage devices. The current Serial ATA interface allows
up to 150 MB/s data transfer rate, faster than the standard parallel ATA
with 133 MB/s (UltraDMA133).
A8AE-LE
A8AE-LE SATA connectors
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA1
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
SATA2
Page view 13
1 ... 13 14 15 16 17 18

Comments to this Manuals

No comments