Asus CUV266-D User Manual download pdf (Page 31)

ASUS CUV266-D User’s Manual 31

3. HARDWARE SETUP

Connectors

3. H/W SETUP

3.8.2 Internal Connectors

2) Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connecting

the single end to the board, connect the two plugs on the other end to the floppy

drives. (Pin 5 is removed to prevent inserting in the wrong orientation when

using ribbon cables with pin 5 plugged).

1) IDE Activity LED (2-pin HDDLED)

This connector supplies power to the HDD activity LED. Read and write activity

by devices connected to the Primary or Secondary IDE connectors cause the

HDD LED to light up.

WARNING! Some pins are used for connectors or power sources. These are

clearly distinguished from jumpers in the Motherboard Layout. Placing jumper

caps over these connector pins will cause damage to your motherboard.

IMPORTANT: Always connect ribbon cables with the red stripe to Pin 1 on the

connectors. Pin 1 is usually on the side closest to the power connector on hard

drives and CD-ROM drives, but may be on the opposite side on floppy disk

drives.

NOTE: Orient the red markings on

the floppy ribbon cable to

PIN 1

CUV266-D Floppy

Disk Drive Connector

PIN 1

CUV266-D

0 10 10 10 1

CUV266-D

0 10 10 10 1

CUV266-D HDD Activity LED

TIP: If the case-mounted LED does not

light, try reversing the 2-pin plug.

HDDLED

1 ... 30 31 32 ... 88

No comments

Asus CUV266-D User Manual Page 31