Asus E7477 User Manual download pdf (Page 160)

5-2

Chapter 5: RAID support

Chapter 5

5.1.2 Installing Serial ATA hard disks

The motherboard supports Serial ATA hard disk drives. For optimal performance, install

identical drives of the same model and capacity when creating a disk array.

To install the SATA hard disks for a RAID conguration:

1. Install the SATA hard disks into the drive bays.

2. Connect the SATA signal cables.

3. Connect a SATA power cable to the power connector on each drive.

5.1.3 Setting the RAID item in BIOS

You must enable the RAID function in the BIOS Setup before creating RAID sets using SATA

HDDs. To do this:

1. Enter the BIOS Setup during POST.

2. Go to

Advanced Mode and go to the Advanced menu > SATA Conguration > SB

SATA Conguration, and press <Enter>.

3. Set the SATA Mode item to [RAID Mode].

4. Save your changes, and then exit the BIOS Setup.

Refer to Chapter 3 for details on entering and navigating through the BIOS Setup

• Due to chipset limitation, when SATA ports are 1-4 are set to RAID mode, SATA ports

1-4 run at RAID mode at the same time.

• When creating a RAID volume using more than four HDDs, ensure that SATA ports

5-6 are set to [RAID] mode.

• When creating a RAID set, set the SATA_5-6 connectors to

[AHCI] mode or [IDE]

mode to ensure that the system recognizes your ODD device.

1 ... 159 160 161 ... 184

No comments

Asus E7477 User Manual Page 160