Asus MEZ User Manual download pdf (Page 27)

ASUS MEZ User’s Manual 27

III. HARDWARE SETUP

Connectors

III. H/W SETUP

11. Chassis, CPU , & Power Supply Fan Connectors (3-pin CHA_, CPU_, PWR_FAN)

These connectors support cooling fans of 500mAMP (6 Watts) or less. Orien-

tate the fans so that the heat sink fins allow airflow to go across the onboard heat

sink(s) instead of the expansion slots. Depending on the fan manufacturer, the

wiring and plug may be different. The red wire should be positive, while the

black should be ground. Connect the fan’s plug to the board taking into consid-

eration the polarity of the this connector. NOTE: The “Rotation” signal is to

be used only by a specially designed fan with rotation signal.

WARNING! The CPU and/or motherboard will overheat if there is no airflow

across the CPU and onboard heatsinks. Damage may occur to the motherboard

and/or the CPU fan if these pins are incorrectly used. These are not jumpers,

do not place jumper caps over these pins.

MEZ 12-Volt Cooling Fan Power

Chassis Fan Power

GND

Rotation

+12V

GND

Rotation

+12V

Power Supply Fan

CPU Fan Power

0 10 10 1

GND

Rotation

+12V

12. Wake-On-LAN Connector (3-pin WOL_CON)

These connector connects to LAN cards with a Wake-On-LAN output, such as the

ASUS PCI-L101. The connector powers up the system when a wakeup packet or

signal is received through the LAN card.

IMPORTANT: This feature requires that the WAKE On LAN Power Up Control is

set to Enabled (see Power Management Setup under BIOS SETUP) and that your

system has an ATX power supply with at least 720mA +5V standby power.

MEZ Wake-On-LAN Connector

IMPORTANT: Requires an ATX power

supply with at least 720mA +5 volt

standby power

+5 Volt Standby

PME

Ground

0 10 10 1

1 ... 26 27 28 ... 104

Comments to this Manuals

No comments

Asus MEZ User Manual Page 27

Comments to this Manuals

Related products and manuals for Motherboards Asus MEZ