Asus P4S533-MX User Manual download pdf (Page 26)

1-16

Chapter 1: Product introduction

1. Floppy disk drive connector (34-1 pin FLOPPY1)

This connector supports the provided floppy drive ribbon cable. After

connecting one end to the motherboard, connect the other end to the floppy

drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables

with pin 5 plug).

2. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

This connector supports the provided UltraDMA133/100/66 IDE hard disk ribbon

cable. Connect the cable’s blue connector to the primary (recommended) or

secondary IDE connector, then connect the gray connector to the

UltraDMA133/100/66 slave device (hard disk drive) and the black connector to

the UltraDMA133/100/66 master device. It is recommended that you connect

non-UltraDMA133/100/66 devices to the secondary IDE connector. If you install

two hard disks, you must configure the second drive as a slave device by setting

its jumper accordingly. Refer to the hard disk documentation for the jumper

settings. BIOS supports specific device bootup. If you have more than two

UltraDMA133/100/66 devices, purchase another UltraDMA133/100/66 cable.

You may configure two hard disks to be both master devices with two ribbon

cables – one for the primary IDE connector and another for the secondary IDE

connector.

Pin 20 on each IDE connector is removed to match the covered hole on the

UltraDMA cable connector. This prevents incorrect orientation when you

connect the cables.

1.12 Connectors

This section describes and illustrates the internal connectors on the motherboard.

P4S533-MX

NOTE: Orient the red markings o

the floppy ribbon cable to PIN 1.

P4S533-MX Floppy Disk Drive Connector

PIN 1

FLOPPY1

P4S533-MX

P4S533-MX IDE Connectors

NOTE: Orient the red marking

on the IDE ribbon cable to

SEC_IDE1

PIN 1

PRI_IDE1

PIN 1

1 ... 25 26 27 ... 64

No comments

Asus P4S533-MX User Manual Page 26