Asus k8vse User's Guide download pdf (Page 30)

1-20

Chapter 1: Product introduction

1.10.2 Internal connectors

1. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

This connector supports the provided UltraATA133 IDE hard disk ribbon cable.

Connect the cable’s blue connector to the primary (recommended) or secondary

IDE connector, then connect the gray connector to the UltraATA133 slave device

(hard disk drive) and the black connector to the UltraATA133 master device.

• Follow the hard disk drive documentation when setting the device in master

or slave mode.

• Pin 20 on each IDE connector is removed to match the covered hole on the

UltraATA cable connector. This prevents incorrect orientation when you

connect the cables.

• The hole near the blue connector on the UltraATA cable is intentional.

2. Floppy disk drive connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After

connecting one end to the motherboard, connect the other end to the floppy

drive. (Pin 5 is removed to prevent incorrect insertion when using ribbon cables

with pin 5 plug).

K8V-X SE

K8V-X SE IDE connectors

NOTE: Orient the red marking

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

SEC_IDE

K8V-X SE

K8V-X SE Floppy disk drive connector

NOTE: Orient the red markings o

the floppy ribbon cable to PIN 1.

FLOPPY

PIN 1

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 81 82

No comments

Asus k8vse User's Guide Page 30