Asus KN97 User Manual download pdf (Page 13)

ASUS KN97-X User’s Manual 13

III. INSTALLATION

Jumpers

1) IOEN p. 15 Multi-I/O Selection (Enable/Disable)

2) BBLKW p. 15 Flash ROM Boot Block Program (Disable/Enable)

3) AUDIO (optional) p. 16 Onboard Audio (Disable/Enable)

4) VOLADJ (optional) p. 16 Digital Volume Level Adjustment (Up/Down)

5) RTCLR p. 17 Real Time Clock RAM (Operation/Clear Data)

6) BATTERY TEST p. 17 Battery Test Lead (Operation/Test Mode)

7) FS0, FS1 p. 18 CPU External Clock (BUS) Frequency Selection

8) BF0, BF1, BF2, BF3 p. 18 CPU:BUS Frequency Ratio

Expansion Slots

1) System Memory p. 19 System Memory Support

2) SIMM Sockets p. 20 SIMM Memory Module Support

3) DIMM Sockets p. 21 DIMM Memory Module Support

2) Pentium II CPU Slot p. 22 Central Processing Unit (CPU) Cartridge Support

3) ISA Slots p. 24 16-bit ISA Bus Expansion Slots*

4) PCI Slots p. 24 32-bit PCI Bus Expansion Slots*

Connectors

1) PS2KEYBOARD p. 26 PS/2 Keyboard Connector (6-pin Female)

2) PS2MOUSE p. 26 PS/2 Mouse Connector (6-pin Female)

3) PRINTER p. 27 Parallel (Printer) Port Connector (25-pin Female)

4) COM1, COM2 p. 27 Serial Port COM1 & COM2 (Two 9-pin Female)

5) AUDIO (optional) p. 27 Audio Port -Line Out, Line In, Mic (Three 1/8” Female)

6) GAME (optional) p. 28 Joystick/Midi Connector (15-pin Female)

7) USB p. 28 Universal Serial BUS Ports 1 & 2 (Two 4-pin Female)

8) FLOPPY p. 28 Floppy Drive Connector (34-pin Block)

9) FANPWR1, 2, 3 p. 29 Chassis, CPU, Power Supply Fan Power (3-pin Block)

10) CHASSIS p. 29 Chassis Open Alarm Lead (3-pin Block)

11) IDE1, IDE2 p. 30 Primary / Secondary IDE Connector (40-pin Blocks)

12) IDELED p. 30 IDE LED Activity Light

13) PWR LED (PANEL) p. 31 System Power LED (2-pins)

14) SMI (PANEL) p. 31 SMI Switch Lead (2-pins)

15) PWR SW (CON1) p. 31 ATX Power & Soft-Off Switch Lead (2-pins)

16) RESET (PANEL) p. 31 Reset Switch Lead (2-pins)

17) KEYLOCK (PANEL) p. 31 Power LED (3-pins) & Keyboard Lock Switch (2-pins)

18) SPEAKER (PANEL) p. 31 Speaker Output Connector (4-pins)

19) IR p. 32 Infrared Port Module Connector

20) ATXPWR p. 32 Motherboard Power Connector (20-pin Block)

*ISA NOTE: The onboard hardware monitor uses the address 290H so legacy ISA

cards must not use this address or else conflicts will occur.

*PCI NOTE: PCI slots 4&5 share the same interrupt number (INT#) so PCI

cards on these two slots must be able to share an INT# or make sure that one of

these PCI cards does not use an INT#.

(Map of Board)

III. INSTALLATION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 63 64

Comments to this Manuals

No comments

Asus KN97 User Manual Page 13

Comments to this Manuals

Related products and manuals for Motherboards Asus KN97