Asus M2NPV-VM Specifications download pdf (Page 36)

1-261-26

1-26

Chapter 1: Product introductionChapter 1: Product introduction

Chapter 1: Product introduction

3.3.

IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)

IDE connectors (40-1 pin PRI_IDE; 40-1 pin SEC_IDE)

The onboard IDE connectors are for Ultra DMA 133/100/66 signal

cable(s). There are three connectors on each Ultra DMA 133/100/66

signal cable: blue, black, and gray. Connect the blue connector to the

motherboard's IDE connector, then select one of the following modes

to configure your device(s).

M2NPV-VM

M2NPV-VM IDE connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PIN 1

SEC_IDE

• Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE

devices.

If any device jumper is set as "Cable-Select," make sure all other device

jumpers have the same setting.

Black or gray

Drive jumperDrive jumper

Drive jumper

ModeMode

Mode

CableCable

Cable

settingsetting

setting

of device(s)of device(s)

of device(s)

connectorconnector

connector

Single device Cable-Select or Master - Black

Two devices Cable-Select Master Black

Slave Gray

Master Master

Slave Slave

1 ... 35 36 37 ... 96

Comments to this Manuals

No comments

Asus M2NPV-VM Specifications Page 36

Comments to this Manuals

Related products and manuals for Motherboards Asus M2NPV-VM