Asus P2B-D2 User Manual download pdf (Page 29)

ASUS P2B-D2 User’s Manual 29

III. INSTALLATION

9. Primary / Secondary IDE Connectors (Two 40-1 pin IDE)

These connectors support the provided IDE hard disk ribbon cable. After con-

necting the single end to the board, connect the two plugs at the other end to

your hard disk(s). If you install two hard disks, you must configure the second

drive to Slave mode by setting its jumper accordingly. Please refer to the docu-

mentation of your hard disk for the jumper settings. BIOS now supports SCSI

device or IDE CD-ROM bootup (see “HDD Sequence SCSI/IDE First” & “Boot

Sequence” in the BIOS Features Setup of the BIOS SOFTWARE) (Pin 20 is

removed to prevent inserting in the wrong orientation when using ribbon

cables with pin 20 plugged).

TIP: You may configure two hard disks to be both Masters using one ribbon

cable on the primary IDE connector and another ribbon cable on the secondary

IDE connector. You may install one operating system on an IDE drive and an-

other on a SCSI drive and select the boot disk through BIOS Features Setup.

P2B-D2 IDE Connectors

NOTE: Orient the red stripe on the

IDE ribbon cable to Pin 1

PIN 1

Primary IDE Connector

Secondary IDE Connector

10. Chassis Intrusion Sensor Lead (CHASSIS)

This lead is for a chassis intrusion monitor or sensor. The sensor is triggered

when a high level signal is sent to the “chassis signal” lead. This occurs when a

panel switch or light detector is triggered. This function requires optional trigger

switches to be installed.

P2B-D2 Chassis Open Alarm Lead

+5VSB

Chassis Signal

Ground

Connectors

III. INSTALLATION

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 95 96

No comments

Asus P2B-D2 User Manual Page 29