Asus P2L97A User Manual download pdf (Page 26)

26 ASUS P2L97A User’s Manual

Connectors

III. INSTALLATION

9. Primary / Secondary IDE Connectors (Two 40-1pin IDE)

These connectors support the provided IDE hard disk ribbon cable.

After connecting the single end to the board, connect the two plugs at the other end

to your hard disk(s). If you install two hard disks, you must configure the second

drive to Slave mode by setting its jumper accordingly. Refer to the documentation

of your hard disk for the jumper settings. (Pin 20 is removed to prevent inserting

in the wrong orientation when using ribbon cables with pin 20 plugged).

Primary IDE Connector

Pin 1

Secondary IDE Connector

IDE Connectors

NOTE: Orient the red stripe to Pin 1

10. IDE activity LED (2-pin IDELED)

This connector supplies power to the cabinet’s IDE activity LED. Read-and-write

activity by devices connected to the IDE connectors will cause the LED to light up.

IDE Activity LED

IDELED

(IDE Signal)

(+5V)

11. Wake on LAN Connector (3-pin WOL_CON)

This connector coonects to LAN cards with a Wake On LAN output. When the

system is in soft-off mode, LAN activity will power on the system.

Wake on LAN Connector

IMPORTANT: Requires an ATX power

supply with at least 720mA +5-volt

standby power

+5-Volt Standby

PME

Ground

1 ... 25 26 27 ... 58

No comments

Asus P2L97A User Manual Page 26