Asus P4P8X User's Guide download pdf (Page 32)

1-22

Chapter 1: Product introduction

3. IDE connectors (40-1 pin PRI_IDE1, SEC_IDE1)

This connector supports the provided UltraDMA100/66 IDE ribbon cable. Connect

the cable’s blue connector to the primary (recommended) or secondary IDE

connector, then connect the gray connector to the UltraDMA100/66 slave device

(hard disk drive) and the black connector to the UltraDMA100/66 master device. It

is recommended that you connect non-UltraDMA100/66 devices to the secondary

IDE connector. If you install two hard disks, you must configure the second drive

as a slave device by setting its jumper accordingly. Refer to the hard disk

documentation for the jumper settings. BIOS supports specific device bootup. If

you have more than two UltraDMA100/66/33 devices, purchase another

UltraDMA100/66/33 cable. You may configure two hard disks to be both master

devices with two ribbon cables – one for the primary IDE connector and another

for the secondary IDE connector.

P4P8X

P4P8X IDE Connectors

NOTE: Orient the red marking

(usually zigzag) on the IDE

ribbon cable to PIN 1.

SEC_IDE1

PRI_IDE1

PIN 1

Refer to the Parallel ATA and Serial ATA device configurations on the next page.

Important note when using legacy OS

Refer to page 1-22 on how to configure P-ATA and S-ATA devices if you

installed a legacy operating system (e.g. MS-DOS, Windows 98/Me/NT4.0).

1. Pin 20 on each IDE connector is removed to match the covered hole on the

UltraDMA cable connector. This prevents incorrect orientation when you

connect the cables.

2. The hole near the blue connector on the UltraDMA100/66 cable is intentional.

3. For UltraDMA100/66 IDE devices, use the 80-conductor IDE cable.

1 ... 31 32 33 ... 84

No comments

Asus P4P8X User's Guide Page 32