Asus SP98-XV User Manual download pdf (Page 34)

34 ASUS SP98-N User’s Manual

Connectors

3. H/W SETUP

3. HARDWARE SETUP

3) NLX Power Supply Connector

This connector connects to an NLX power supply. The plug from the power sup-

ply will only insert in one orientation because of the different size holes. Find the

proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that the NLX power supply can deliver at least 720mA

on the 5volt standby lead (+5VSB). You may experience difficulty in powering

on your system if your power supply cannot support the load. For Wake-On-LAN

support, your NLX power supply must supply at least 720mA +5VSB.

NLX Power Connector

+3.3 Volts

-12.0 Volts

Ground

Power Supply On

Ground

-5.0 Volts

+5.0 Volts

Power Good

+12.0 Volts

+3.3 Volts

Ground

+5.0 Volts

Ground

+5.0 Volts

Ground

+5V Standby

NLX-R (Back)

Yeong-Yang (Back)

NLX Power Supply Connector

IMPORTANT: Ultra DMA/66 devices require a 40-pin 80-conductor cable to

be enabled and/or for Ultra DMA Mode 4.

4) IDE Connectors

This connector supports the provided IDE hard disk drive ribbon cable. After

connecting one end to the riser card, connect the other end to a hard disk drive.

The primary IDE channel supports both a master and a slave IDE device but the

system housing size only permits a standard IDE hard drive to be installed.

IDE Connectors

Orient the red stripe on the

IDE ribbon cable to Pin 1

Pin 1

YEONG-YANG

NLX-R (Back)

Yeong-Yang (Front)

1 ... 33 34 35 ... 112

Comments to this Manuals

No comments

Asus SP98-XV User Manual Page 34

Comments to this Manuals

Related products and manuals for Motherboards Asus SP98-XV