Asus RX3041H User Manual download pdf (Page 77)

RX3041H User’s Manual Chapter 9. Configuring Firewall/NAT Settings

9.7.1 Configuring Self Access Rules

Self access rules are used to control access to the router itself.

9.7.1.1 Self Access Configuration Parameters

Table 9.3 describes the configuration parameters available in the Self Access configuration page.

Table 9.3. Self Access Configuration Parameters

Field Description

Protocol

Select protocol from drop down list - TCP/ UDP/ICMP

Port

Enter the Port Number.

Direction

Select the direction from which the traffic will be allowed.

From LAN Select Enable or Disable to allow or deny traffic from the LAN (internal

network) to the RX3041H.

From WAN Select Enable or Disable to allow or deny traffic from WAN (external

network) to the RX3041H.

9.7.1.2 Add a Self Access Rule

To add a Self Access rule, follow the instructions below:

1. Open the Self Access Rule configuration page by clicking on the Firewall

Î Advanced Î Self Access menu.

2. Select “Add New” from the Self Access rule drop-down list.

3. Select a protocol from the Protocol drop-down list. If you select TCP or

UDP protocol, you will need to enter port number as well.

Figure 9.13. Self Access Rule Configuration Example

4. Click on the button to create the new Self Access rule. The new rule will then be

displayed in the Self Access Rule list table at the bottom half of the Self Access Rule

configuration page.

Example

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 142 143

No comments

Asus RX3041H User Manual Page 77