Asus P4T533-C User Manual Page 47

  • Download
  • Add to my manuals
  • Print
  • Page
    / 128
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 46
ASUS P4T533-C motherboard user guide
33
9. IDE Connectors (2 x 40-1 pin PRI_IDE / SEC_IDE)
This connector supports the provided UltraDMA/100/66 IDE hard disk
ribbon cable. Connect the cables blue connector to the IDE1
(recommended) or to the IDE2 connector; then connect the gray connector
to the UltraDMA/100/66 slave device (hard disk drive) and the black
connector to the UltraDMA/100/66 master device. It is recommended
that you connect non-UltraDMA/100/66 devices to the secondary IDE
connector. If you install two hard disks, you must configure the second
drive as a slave device by setting its jumper accordingly. Refer to the
hard disk documentation for the jumper settings. BIOS supports specific
device bootup. If you have more than two UltraDMA/100/66 devices,
purchase another UltraDMA/100/66 cable. You may configure two hard
disks to be both master devices with two ribbon cables one for the
primary IDE connector and another for the secondary IDE connector.
1. Pin 20 on each IDE connector is removed to match the covered
hole on the UltraDMA cable connector. This prevents incorrect
orientation when you connect the cables.
2. The hole near the blue connector on the UltraDMA/100/66 cable is
intentional.
For UltraDMA/100/66 IDE devices, use an 80-conductor IDE cable. The
UltraDMA/66 cable included in the motherboard package also supports
UltraDMA/100.
P4T533-C
®
P4T533-C IDE Connectors
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SEC_IDE Connector
PIN 1
PRI_IDE Connector
PIN 1
Page view 46
1 ... 46 47 48 ... 128

Comments to this Manuals

No comments