Asus P4S533 User's Guide Page 60
- Page / 132
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
46
Chapter 3: Powering up
3.2 Vocal POST Messages
This motherboard includes the Winbond speech controller to support a
special feature called the ASUS POST Reporter™. This feature gives you
vocal POST messages and alerts to inform you of system events and boot
status. In case of a boot failure, you will hear the specific cause of the
problem.
These POST messages are customizable using the Winbond Voice Editor
software that came with your package. You can record your own
messages to replace the default messages.
Following is a list of the default POST messages and their corresponding
actions, if any.
POST Message Action
No CPU installed • Install an Intel Pentium 4
478/Northwood Processor into the
CPU socket.
System failed CPU test • Check the CPU if properly installed.
• Call ASUS technical support for
assistance. See the “ASUS contact
information” and www.asus.com.
System failed memory test • Install 184-pin unbuffered
DDR SDRAM DIMMs into the DIMM
sockets.
• Check if the DIMMs on the DIMM
sockets are properly installed.
• Make sure that your DIMMs are
not defective.
• Refer to section “2.5 System
memory” for instruction on installing
a DIMM.
System failed VGA test • Install a PCI VGA card into one of
the PCI slots, or a 1.5V AGP card
into the AGP slot.
• Make sure that your VGA/AGP card
is not defective.
System failed due to CPU • In JumperFree mode, check your
over-clocking CPU settings in BIOS and make
sure you only set to the recom-
mended settings. See section “4.4
Advanced menu.”
• In jumper mode, refer to section
“2.7 Jumpers.”
- Motherboard 1
- P4S533-E 2
- June 2002 2
- About this guide 3
- Contents 4
- Safety information 6
- FCC/CDC statements 7
- ASUS contact information 8
- Chapter 1 9
- ASUS P4S533-E motherboard 10
- Welcome! 11
- Core Specifications 12
- 1.3 Special Features 13
- Motherboard Components 14
- 1.4.1 Component Locations 15
- 1.5 Value-added solutions 16
- Chapter 2 17
- 2.1 Motherboard installation 19
- 2.2 Motherboard layout 20
- 2.2.1 Layout contents 21
- 2.3 Before you proceed 22
- 2.4.1 Overview 23
- 90 - 100 24
- Gold Mark 25
- Retention Module Base 26
- CPU Heatsink 26
- Retention Hole 27
- Retention Hook Snapped 27
- Retention Lock 27
- CPU Fan Connector (CPUFAN1) 28
- 104 Pins 29
- 2.5.2 Memory configurations 30
- 2.5.3 Installing a DIMM 31
- 2.5.4 Removing a DIMM 32
- 2.6 Expansion slots 33
- 2.7 Jumpers 36
- P4S533-E CPU 37
- External Frequency Selection 37
- P4S533-E USB Device Wake Up 38
- P4S533-E DDRVOL Setting 39
- (Default) 40
- P4S533-E Speaker Selector 41
- P4S533-E Clear RTC RAM 42
- CLRCMOS1 42
- 2.8 Connectors 43
- Serial Ports (9-pin male) 44
- 5. SOFTWARE SETUP 45
- P4S533-E IDE Activity LED 46
- P4S533-E IDE Connectors 47
- +12V DC COM 49
- P4S533-E Chassis Alarm Lead 51
- CHASSIS1 51
- P4S533-E Smartcard 52
- SMARTCON1 52
- BLINE_LIN_R 53
- ALINE_LIN_R 53
- BLINE_IN_L 53
- ALINE_IN_L 53
- IAPANEL1 54
- P4S533-E IEEE-1394 Headers 55
- IEEE-1394_2 (white) 55
- IEEE-1394_3 (white) 55
- Chapter 3 57
- Award BIOS Beep Codes 59
- 3.2 Vocal POST Messages 60
- POST Message Action 61
- 3.3 Powering off the computer 62
- Chapter 4 63
- 4.2 BIOS Setup program 69
- 4.2.1 BIOS menu bar 70
- 4.2.2 Legend bar 70
- General help 71
- Scroll bar 71
- Sub-menu 71
- 4.3 Main menu 72
- Type [Auto] 73
- [User Type HDD] 74
- SMART Monitoring [Disabled] 76
- PIO Mode [4] 76
- Ultra DMA Mode [Disabled] 76
- 4.3.2 Keyboard Features 77
- Installed Memory [XXX MB] 78
- Language [English] 78
- A note about passwords 78
- Halt On [All Errors] 78
- 4.4 Advanced Menu 79
- 4.4.1 Chip Configuration 81
- Onboard PCI IDE Enable [Both] 83
- UART2 Use As [Disabled] 84
- Parallel Port Mode [ECP+EPP] 85
- ECP DMA Select [3] 85
- 4.4.3 PCI Configuration 86
- Onboard LAN [Enabled] 87
- USB 2.0 Function [Enabled] 87
- IRQ XX Reserved [No/ICU] 88
- 4.5 Power Menu 89
- 4.5.1 Power Up Control 91
- Automatic Power Up [Disabled] 92
- 4.5.2 Hardware Monitor 93
- 4.6 Boot Menu 94
- ASUS MyLogo2™ feature 95
- 4.7 Exit Menu 96
- Load Setup Defaults 97
- Discard Changes 97
- Save Changes 97
- Chapter 4: BIOS Setup 98
- Chapter 5 99
- 5.2 Support CD information 101
- 5.3.1 Installation Menu 102
- 5.4 ASUS PC Probe 104
- 5.4.2 Using ASUS PC Probe 105
- Information 106
- 5.5 ASUS Live Update 109
- 5.6 3Deep Color Tuner 110
- 5.6.2 The 3Deep Control Panel 111
- 5.7 ITE GSM Editor 112
- The ITE GSM menu: 113
- Using the Command field: 114
- Using the PIN Manager: 115
- 5.8 Winbond Voice Editor 116
- Changing the default language 117
- Chapter 5: Software reference 120
- Glossary 121
- Appendix: Glossary 124
Related products and manuals for Server/workstation motherboards Asus P4S533
(168 pages)© 2020, manymanuals.com. All rights reserved. | 0.044 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals