Asus P5QL-CM Specifications download pdf (Page 35)

ASUS P5QL-CM 1-25

6. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect

one end of the chassis intrusion sensor or switch cable to this connector. The chassis

intrusion sensor or switch sends a high-level signal to this connector when a chassis

component is removed or replaced. The signal is then generated as a chassis intrusion

event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper

cap. Remove the jumper caps only when you intend to use the chassis intrusion

detection feature.

5. Floppy disk drive

connector (34-1 pin FLOPPY)

This connector is for the provided oppy disk drive (FDD) signal cable. Insert one end

of the cable to this connector, then connect the other end to the signal connector at the

back of the oppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using an

FDD cable with a covered Pin 5.

The Floppy Disk Drive cable is purchased separately.

P5QL-CM

P5QL-CM Floppy disk drive connector

FLOPPY

NOTE:Orient the red markings

on the floppy ribbon cable to PIN 1.

PIN1

P5QL-CM

+5VSB_MB

Chassis Signal

GND

CHASSIS

P5QL-CM Chassis intrusion connector

1 ... 34 35 36 ... 60

No comments

Asus P5QL-CM Specifications Page 35