Asus P5SD2-FM Specifications download pdf (Page 35)

ASUS P5SD2-FM 1-27

3. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

These connectors are for a Ultra DMA 100/66 signal cable. The Ultra DMA 100/

66 signal cable has three connectors: a blue connector for the primary IDE

connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE

slave device (optical drive/hard disk drive), and a gray connector for an Ultra

DMA 100/66 IDE master device (hard disk drive). If you install two hard disk

drives, you must configure the second drive as a slave device by setting its

jumper accordingly. Refer to the hard disk documentation for the jumper

settings.

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

P5SD2-FM IDE Connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

PIN 1

SEC_IDE

P5SD2-FM

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 67 68

No comments

Asus P5SD2-FM Specifications Page 35