Asus CUR-DLS User's Guide download pdf (Page 33)

4. Hardware Setup

AP2300 Hardware Reference Guide

SCSI ID settings are made through DIP switches located on the SCSI

backplane board. The SCSI backplane board has 6 DIP switches to set the

hard drive’s power-ON delay and SCSI ID.

• 4-13 SCSI ID Setting

SCSI ID Setting

123456

Default Settings

SCSI ID#s are determined by the host – A SCSI hard

drive mounted in a hot-swap “tray” will not have a SCSI

“ID” until it is inserted into a hot-swap “bay”.

123456

Resulting SCSI ID#s

Top Bay ID

Tray5 12

Tray4 08

Tray3 04

Tray2 02

Tray1 00

Bottom Bay

Switch 5 OFF

Switch 5 ON

Resulting SCSI ID#s

Top Bay ID

Tray5 13

Tray4 09

Tray3 05

Tray2 03

Tray1 01

Bottom Bay

123456

Delay HD motor spin-up (12 x SCSI ID in milliseconds) (ON)

Remote HD motor spin-up initiated (OFF)

Bay SCSI ID Setting (see below)

Reserved

All SCSI devices must have a SCSI identification number that is not in

use by any other SCSI device. SCSI devices vary in how they set the

ID number. Refer to the product manual for any additional devices that

you may install for details on how to set its ID number.

NOTE

1 ... 32 33 34 ... 44

No comments

Asus CUR-DLS User's Guide Page 33