Chapter 2: Hardware setup
2-14
2.4 Hard disk drives
The system supports four hot-swap SATA/SAS hard disk drives. The hard disk drive installed
on the drive tray connects to the motherboard SATA/SAS ports via the SATA/SAS backplane.
To install a hot-swap SATA/SAS HDD:
1. Pushthespringlocktotheright(A)thenpullthetrayleveroutward(B)toreleasethe
drive tray. The drive tray ejects slightly after you pull out the lever.
2. Firmly hold the tray lever and pull the
drive tray out of the bay.
3. Placethedrivetrayonaatand
stable surface.
4. Prepare the SATA/SAS HDD and the
bundled set of screws.
spring lock
tray lever
Comments to this Manuals