Asus PEM-FDR User Manual download pdf (Page 10)

1-4

Chapter 1: Product introduction

1.5 Replacing the card bracket

The ASUS PEM-FDR card is bundled with a full-heigth bracket, a low-prole bracket, and

an ASUS proprietary bracket. By default, the card is pre-installed with an ASUS proprietary

bracket.

The proprietray bracket is a small bracket for node that supports ASUS Z10PH-D16 series,

ES4000 G3 series, and RS720Q-E8 series models. The supported list of models are

subject to change without prior notice.

To replace the card bracket:

1. Get the

PEM-FDR card and place it on a stable and at surface. Ensure that the

printed circuit board (PCB) is facing down.

2. Remove the two screws that secures the PEM-FDR card to the card bracket then

remove the card bracket.

3. Get the replacement card bracket.

4. Align and insert the PEM-FDR card into the mounting hole of the card bracket. Ensure

that the screw holes on the PEM-FDR card matches the screw holes of the card

bracket.

5. Replace the screws that you removed earlier in step 2.

screw

replacement card bracket

default card bracket

screw

1 ... 9 10 11 ... 24

No comments

Asus PEM-FDR User Manual Page 10