Asus M2A-MVP User Manual download pdf (Page 42)

1-30 Chapter 1: Product introduction

4. Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch.

Connect one end of the chassis intrusion sensor or switch cable to this

connector. The chassis intrusion sensor or switch sends a high-level signal to

this connector when a chassis component is removed or replaced. The signal

is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with

a jumper cap. Remove the jumper caps only when you intend to use the

chassis intrusion detection feature.

M2A-MVP

M2A-MVP Chassis intrusion connector

CHASSIS

+5VSB_MB

Chassis Signal

GND

(Default)

• Plug your Serial ATA boot disk on the master port (SATA1/2 to support S3

function).

• Install the Windows

2000 Service Pack 4 or the Windows

XP Service Pack1

or later when using Serial ATA.

Connector Color Setting Use

SATA1/SATA2 Red Master Boot disk

SATA3/SATA4 Black Slave Data disk

Serial ATA hard disk drive connection

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 105 106

No comments

Asus M2A-MVP User Manual Page 42