Asus M2V User Manual download pdf (Page 43)

2-22

Chapter 2: Hardware information

2.7.2 Internal connectors

1. IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for the Ultra DMA 133/100/66 signal

cable. There are three connectors on each Ultra DMA 133/100/66

signal cable: blue, black, and gray. Connect the blue connector to the

motherboard’s IDE connector, then select one of the following modes

to congure your device.

M2 V

M2V IDE Connectors

NOTE: Orient the red markings

(usually zigzag) on the IDE

ribbon cable to PIN 1.

PRI_IDE

SEC_IDE

• Pin 20 on the IDE connector is removed to match the covered hole on the

Ultra DMA cable connector. This prevents incorrect insertion when you

connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

Drive jumper setting Mode of

device(s)

Cable connector

Single device Cable-Select or Master - Black

Two devices Cable-Select Master

Black

Slave Gray

Master Master Black or gray

Slave Slave

If any device jumper is set as “Cable-Select,” make sure all other device

jumpers have the same setting.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 116 117

No comments

Asus M2V User Manual Page 43