Asus M4N75TD User Manual download pdf (Page 35)

1.12.2 Internal connectors

1. IDE connector (40-1 pin PRI_IDE)

The onboard IDE connector is for Ultra DMA 133/100/66 signal cable. There are three

connectors on each Ultra DMA 133 / 100 / 66 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to congure your devices:

Drive jumper setting Mode of device(s) Cable connector

Single device Cable-Select or Master - Black

Two devices

Cable-Select

Master Black

Slave Gray

Master Master

Black or gray

Slave Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

If any device jumper is set as “Cable-Select”, ensure that all other device jumpers have the

same setting.

Chapter 1: Product introduction 1-23

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 77 78

No comments

Asus M4N75TD User Manual Page 35