Asus P5QL SE User Manual download pdf (Page 31)

ASUS P5QL SE 1-21

3. IDE connector (40-1 pin PRI_EIDE)

The onboard IDE connector is for an Ultra DMA 133/100/66 signal cable. There are

three connectors on an Ultra DMA 133/100/66 signal cable: blue, black, and gray.

Connect the blue connector to the motherboard’s IDE connector, then select one of the

following modes to congure your device.

Drive jumper setting Mode of device(s) Cable connector

Single device Cable-Select or Master - Black

Two devices

Cable-Select

Master Black

Slave Gray

Master Master

Black or gray

Slave Slave

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA

cable connector. This prevents incorrect insertion when you connect the IDE cable.

• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.

PRI_IDE

NOTE:Orient the red markings

on the IDE ribbon cable to PIN 1.

PIN1

P5QL SE

P5QL SE IDE connector

If any device jumper is set as

“Cable-Select,” ensure that all other

device jumpers have the same

setting.

4. Optical drive audio connector (4-pin CD)

These connectors allow you to receive stereo audio input from sound sources such as

a CD-ROM, TV tuner, or MPEG card.

Right Audio Channel

GND

Left Audio Channel

P5QL SE

P5QL SE Internal audio connector

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 59 60

No comments

Asus P5QL SE User Manual Page 31