Asus TUEP2-M User Manual download pdf (Page 45)

ASUS TUEP2-M User’s Manual 45

4. BIOS SETUP

Updating BIOS

4.1 Managing and Updating Your BIOS

4.1.1 Upon First Use of the Computer System

It is recommended that you save a copy of the original motherboard BIOS

along with a Flash Memory Writer utility (AFLASH.EXE) to a bootable

floppy disk in case you need to reinstall the BIOS later. AFLASH.EXE is a

Flash Memory Writer utility that updates the BIOS by uploading a new

BIOS file to the programmable flash ROM on the motherboard. This file

works only in DOS mode. To determine the BIOS version of your

motherboard, check the last four numbers of the code displayed on the upper

left-hand corner of your screen during bootup. Larger numbers represent a

newer BIOS file.

1. Type FORMAT A:/S at the DOS prompt to create a bootable system

disk. DO NOT copy AUTOEXEC.BAT and CONFIG.SYS to the disk.

2. Type COPY D:\AFLASH\AFLASH.EXE A:\ (assuming D is your

CD-ROM drive) to copy AFLASH.EXE to the boot disk you created.

NOTE: AFLASH works only in DOS mode. It does not work in the DOS

prompt within Windows and does not work with certain memory drivers

that may be loaded when you boot from the hard drive. It is recommended

that you reboot using a floppy disk.

3. Reboot the computer from the floppy disk.

NOTE: BIOS setup must specify “Floppy” as the first item in the boot

sequence.

4. In DOS mode, type A:\AFLASH <Enter> to run AFLASH.

IMPORTANT! If the word “unknown” appears after Flash Memory:, the

memory chip is either not programmable or is not supported by the ACPI BIOS

and therefore, cannot be programmed by the Flash Memory Writer utility.

4. BIOS SETUP

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 103 104

No comments

Asus TUEP2-M User Manual Page 45