Asus CUW-FX User Manual download pdf (Page 29)

3. HARDWARE SETUP

Connectors

3. H/W SETUP

ASUS CUW(E)-FX User’s Manual

3.8 External Connectors

WARNING! Some pins are used for connectors or power sources. These are

clearly distinguished from jumpers in the Motherboard Layout. Placing jumper

caps over these connector pins will cause damage to your motherboard.

IMPORTANT: Ribbon cables should always be connected with the red stripe to

Pin 1 on the connectors. Pin 1 is usually on the side closest to the power connec-

tor on hard drives and CD-ROM drives, but may be on the opposite side on

floppy disk drives. Check the connectors before installation because there may

be exceptions. Look on IDE ribbon cable must be less than 46 cm (18 in.), with

the second drive connector no more than 15 cm (6 in.) from the first connector.

NOTE: Onboard Fast-Ethernet is optional at the time of purchase. The fast ethernet

port connector is available only on the LAN model. The illustrations below are that

of the model without the onboard Fast-Ethernet.

1) PS/2 Mouse Connector (Green 6-pin PS2KBMS)

The system will direct IRQ12 to the PS/2 mouse if one is detected. If one is not

detected, expansion cards can use IRQ12. See PS/2 Mouse Function Control

in 4.4 Advanced Menu.

PS/2 Mouse (6-pin female)

2) PS/2 Keyboard Connector (Purple 6-pin PS2KBMS)

This connection is for a standard keyboard using an PS/2 plug (mini DIN). This

connector will not allow standard AT size (large DIN) keyboard plugs. You

may use a DIN to mini DIN adapter on standard AT keyboards.

PS/2 Keyboard (6-pin female)

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 127 128

No comments

Asus CUW-FX User Manual Page 29