Asus k8vse User's Guide download pdf (Page 58)

2-22

Chapter 2: BIOS Setup

2.4.5 System Frequency/Voltage Configuration

CPU FSB Frequency [200MHz]

Allows you to adjust the CPU FSB operating frequency.

Configuration options: [200MHz] [201 MHz] ~ [300MHz]

CPU Speed/Voltage Setting [Auto]

Allows you to set the CPU speed and voltage setting.

Configuration options: [Auto] [Manual]

CPU Multiplier [4.0]

Allows you to manuallyset the CPU speed. The configuration options vary

depending on the speed of the processor installed. This item appears only

when the CPU Speed/Voltage Setting item is set to Manual.

CPU Voltage [1.450 V]

Allows you to manually set the CPU voltage. The configuration options vary

depending on the speed of the processor installed. This item appears only

when the CPU Speed/Voltage Setting item is set to Manual.

Config System Frequency/Voltage

CPU FSB Frequency [200 MHz]

CPU Speed/Voltage Setting [Auto]

AGP/PCI Frequency (MHz) [Auto]

CPU Voltage Adjust [None]

Setting a low CPU voltage can cause system boot failure!

Allocate IRQ to PCI VGA [Yes]

When set to [Yes], BIOS assigns an IRQ to PCI VGA card if the card requests for

an IRQ. When set to [No], BIOS does not assign an IRQ to the PCI VGA card even

if requested. Configuration options: [Yes] [No]

Palette Snooping [Disabled]

When set to [Enabled], the pallete snooping feature informs the PCI devices that

an ISA graphics device is installed in the system so that the latter can function

correctly. Setting to [Disabled] deactivates this feature.

Configuration options: [Disabled] [Enabled]

IRQ xx [Available]

When set to [Available], the specific IRQ is free for use of PCI/PnP devices. When

set to [Reserved], the IRQ is reserved for legacy ISA devices.

Configuration options: [Available] [Reserved]

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 81 82

No comments

Asus k8vse User's Guide Page 58