4-18 Chapter 4: BIOS setup
When USB Function set to [2 USB Ports] [4 USB Ports] the following items
appear.
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB. The AUTO option
disables legacy support if there is no USB device connected.
Conguration options: [Disabled] [Enabled] [Auto]
USB 2.0 Controller [Enabled]
Allows you to enable or disable the USB 2.0 controller.
Conguration options: [Enabled] [Disabled]
USB2.0 Controller mode [HiSpeed]
Allows you to select the USB2.0 controller mode.
Conguration options: [FullSpeed] [HiSpeed]
BIOS EHCI Hand-Off [Enabled]
Allows yout to enable or disable the BIOS EHCI Hand-Off support function.
Conguration options: [Disabled] [Enabled]
USB Mass Storage Device Conguration
USB Mass Storage Reset Delay [20 Sec]
Allows you to set the time that POST waits for the USB mass storage device after
starting unit command. Conguration options: [10 Sec] [20 Sec] [30 Sec] [40 Sec]
Emulation Type [Auto]
Allows you to select device emulation type. If set to Auto, the part of less than
530MB of USB devices is emulated as oppy disk, and the rest part is emulated
as hard disk. Conguration options: [Auto] [Floppy] [Forced FDD] [Hard Disk]
[CDROM]
Select Screen
Select Item
+- Change Option
F1 General Help
F10SaveandExit
ESCExit
BIOS SETUP UTILITY
Advanced
USBMassStorageDeviceConguration
USBMassStorageResetDelay [20Sec]
Device #1 Netac
EmulationType [Auto]
Number of Seconds
POST waits for the
USB mass storage
device after start
unit command.
Comments to this Manuals