Chapter 2: Hardware setup2-2
2.1 Chassis cover
2.1.1 Removing the cover
1. Use a Phillips screwdriver to remove the screw on each front end of the top
cover.
4. Firmly hold the cover and slide it
toward the rear panel for about half
an inch until it is disengaged from
the chassis.
5. Lift the cover from the chassis.
2. Loosen the two thumbscrews on the
rear panel to release the top cover
from the chassis.
1/2 inch distance
Thumbscrews
3. Remove the screws on both sides of
the chassis.
Comments to this Manuals