Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setupChapter 2: Hardware setup
Chapter 2: Hardware setup
2-262-26
2-262-26
2-26
2.9.22.9.2
2.9.22.9.2
2.9.2
SATA backplane connectionsSATA backplane connections
SATA backplane connectionsSATA backplane connections
SATA backplane connections
A SATA backplane comes pre-installed in the TW510-E2 AA4 model. The
SATA backplane has four SATA signal and power connectors to support
Serial ATA hard disk drives. The backplane design incorporates a hot swap
feature to allow easy connection or removal of SATA hard disks. The LED
on the backplane connect to the front panel LED to indicate HDD status.
See section “1.6 LED information” for details.
Front sideFront side
Front sideFront side
Front side
The front side of the SATA backplane faces the front panel when installed.
This side includes four SATA connectors for the hot swap drive trays.
Each SATA connector is labeled
(CON1, CON3, CON5, CON7) so you
can easily determine their
counterpart connectors at the back
side of the backplane. Refer to the
table for reference.
HDDHDD
HDDHDD
HDD
Front sideFront side
Front sideFront side
Front side
Back sideBack side
Back sideBack side
Back side
DeviceDevice
DeviceDevice
Device
connectorconnector
connectorconnector
connector
connectorconnector
connectorconnector
connector
HDD 1 CON1 CON2
HDD 2 CON3 CON4
HDD 3 CON5 CON6
HDD 4 CON7 CON8
Drive status LEDsDrive status LEDs
Drive status LEDsDrive status LEDs
Drive status LEDs
CON1CON1
CON1CON1
CON1
CON3CON3
CON3CON3
CON3
CON5CON5
CON5CON5
CON5
CON7CON7
CON7CON7
CON7
Comments to this Manuals