Asus Motherboard PR-DLS533 User Manual download pdf (Page 130)

5-36

Chapter 5: Driver installation

5.6 SCO OpenServer 5.0.6a

5.6.1 LSI

SCSI Driver Installation

A. Building the SCO OpenServer BTLD Diskette

To create a BTLD diskette for SCO OpenServer system, copy the raw dd

image file onto a 1.44MB floppy disk. This process is dependent upon the

operating system that you are using to create this diskette. See the

instructions below for UNIX System and DOS System Users.

Locate the SCSI files in the following path in the support CD:

\Drivers\SCSI\Fusion-MPT\SCO\1.03.17

For UNIX System Users:

Follow these steps to create the BTLD diskette:

1. Insert a 3.5" diskette into the floppy disk drive.

2. At the UNIX prompt, type:

dd if=/<path>/sco10317 of=/dev/fd0

The <path> represents the directory where you copied the dd image file.

This command will dd the image to the blank diskette to create a BTLD

diskette.

For DOS System Users:

1. Use a utility that will copy the raw dd image onto a 1.44 Mbyte

diskette. RAWRITE3.COM, which is a public domain utility, is

available. Instructions for using this utility are included in its

accompanying RAWRITE3.COM file.

2. The dd image is located in the zipped file you downloaded from the

LSI Logic web site.

3. RAWRITE3.COM is included within the zipped file. After the image

has been copied to a 3.5-inch diskette, use this BTLD diskette for

SCO OpenServer installations as instructed.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 141 142

No comments

Asus Motherboard PR-DLS533 User Manual Page 130